Feb 21, 2024 Leave a message

So The Chiller Needs Defrosting Too? !

So the chiller needs defrosting too? !

Chiller because it can force air supply, improve heat transfer efficiency; With water tray, convenient defrosting, can adapt to various working conditions; Relatively cheap cost, low initial investment; It has become the most common evaporator used in refrigeration system. This article will look at the cooler defrosting method.

 

DSC8000


1, the operator into the cold storage for artificial defrosting, this defrosting method can ensure that the frost does not melt on the ground is cleaned, in the defrosting evaporator can be used normally, this defrosting method requires workers to work in the cold storage, indirectly increasing the amount of cold storage in the cold storage, the need for a certain amount of labor costs.


2. The spray pipe is installed on the evaporator to defrost by spraying pressure water to the frosting part. The method of flushing frost with water is simple to operate and can achieve automatic control, but this method consumes electricity water and needs to be combined with hot gas defrosting. When using hot gas defrosting, the refrigerant inside the evaporator needs to be discharged first, and then the equipment defrosting treatment.


3, cold storage defrosting the most commonly used way is electric heating defrosting treatment, generally used in the use of fin tube cooler, the electric heating element installed on the fin, the water tray and drainage pipe on the road also need to install the heater, mainly to prevent the cold water after defrosting secondary icing situation, you can timely discharge the water outside the cold storage, this way is simple to control, Defrosting efficiency is high, the disadvantage is that the energy consumption is too high.
Read the content of the defrosting method of the chiller in this article, I hope you can absorb it and solve your problems.

Send Inquiry

whatsapp

Phone

E-mail

Inquiry